SPECIFICATIONS

PAVING & KERBING TAMPER REMAC CODE BB1/S
With 150mm x 150mm x 150mm base manufactured from black high density polyethylene
(TECAFINE PE H/D) extruded to DIN 16 985, c/w 150mm x 150mm x 40mm thick black
rubber (NR 8313) striking pad fixed to base block with four 12mm diam. z /p high tensile steel cap screws. Base unit fitted with 38mm diam ERW steel tube shaft, powder coated black finish.

Removable plastic end cap on shaft. NOTE: A quantity of steel shot is placed in the shaft at our works in order to reduce the level of recoil in use. Further steel shot can be added to the shaft to increase the overall weight if required.
Weight of unit ex-works = 7.25kgs (16lbs). O/All height of unit = 1.3metres.

HEAVY DUTY SLAB & KERB BEATER REMAC CODE BB4/H/D
Manufactured from 150mm diam. ‘TECAST’ cast black nylon 6 rod to DIN 16 985. C/w 150mm diam. x 40mm thick black rubber (NR8313) striking pad screwed to bottom of beater with three 12mm diam. z /p high tensile steel cap screws.
Weight of unit = 12.9kgs (28.4lbs) O/All height of unit = 1050mm.


HEAVY DUTY KERB BEATER REMAC CODE BB5/H/D/K
Manufactured from 150mm diam ‘TECAST’ cast black nylon 6 rod to DIN 16 985. C/w 75mm diam x 40mm thick black rubber (NR8313) striking pad bonded and then screwed to bottom of beater with one 12mm diam z /p high tensile steel cap screw.
Weight of unit = 14.6kgs (32.1lbs) O/All height of unit = 1040mm.


TAR TAMPER REMAC CODE BB6/TT
With 200mm x 100mm x 50mm thick mild steel base c/w 38mm diam ERW steel tube handle fixed with steel dowel to base block.
Powder coated black finish.
Weight of unit = 11.34kgs (25lbs) O/All height of unit = 1.2metres


KERBING WRACKING IRON REMAC CODE BB7/WI
Manufactured from steel with flat chisel point welded to 20mm diam bar c/w ball end.
Weight of unit = 11.34kgs (25lbs) O/All height of unit = 1.2metres



Remac ‘Black Belt’ paving, kerbing and tar tampers are quality products manufactured at our factory in Scotland. We have used a combination of steel, nylon, polyethylene, and rubber in the construction of our beaters thus creating a product considerably more durable and stable than the various timber tampers on the market. The main base and shaft, excluding striking pad, of all our black beaters is guaranteed for two years (normal wear and tear) and replacement rubber striking pads can be ordered from our works if required. Several of our beaters feature a dead hammer effect due to steel shot being placed in the shaft. Additional shot can be supplied to
increase the weight of the beater if required. In the event of any ‘Black Belt’ beaters being damaged, we operate a full repair and refurbishment service.

 
124 MUIRHALL TERRACE SALSBURGH , SHOTTS ML74LX SCOTLAND TEL / FAX 01698870771
www.remacservices.com info@remacservices.com